PDFsharp & MigraDoc Forum

Hello, is it possible to remove blank pages from my document?

Hi!

MigraDoc I assume?
Pages do not exist before the document is being prepared.

Empty pages can be the result of adding empty paragraphs or starting new sections. In most cases unwanted empty pages can be avoided by changing the code that creates the document.

I think it is possible to check the contents of a page before rendering it to PDF. But removing the page at this stage will lead to incorrect page numbers.
It's better to create the document without excessive empty pages.

_________________
Best regards
Thomas
(Freelance Software Developer with several years of MigraDoc/PDFsharp experience)

Hi,

yes i am using migradoc. My sites contains 2 Tables, 1 is kind of a head but is not needed on every site,
because the second table might be longer than the rest of the site, and needs to go on on the next page,
After creating and filling both tables i add a pagebreak. So basically blank pages happen whenever
the content of the page before goes to the last possible position on the bottom.

It would be very helpful if i could check the content before rendering...because the program is done after
rendering for whatever reason, which means i cant reopen the pdf and check it.
Page numbers dont matter at all.

Greetings an thanks for the quick answer !

I would start a new section (implies a pagebreak) instead of adding a pagebreak.
This should prevent empty pages.
Only start a new section after the second table if some contents will follow.

_________________
Best regards
Thomas
(Freelance Software Developer with several years of MigraDoc/PDFsharp experience)

Thank you for the tip but that didn´t help. I apologize, it was my fault in the first place.
I made the table borders invisible and i had 1 additional border withtout content on the blank pages,
which explains a lot.
Again thanks a lot for the effort though!