Hi,
I have received two .eps files, each should take up an entire page in my PDF document. I am adding these .pdf files to my main PDF as images (I have done this many times before) and the first page fails when I open the .pdf with the message "There was an error processing a page. Array length is out of scope", but the 2nd page works ok. The graphic I am adding to the 2nd page is quite a bit simpler than that on the first page, which I guess is why its failing, but my question is:
Is there some kind of setting to use on images which have been added to a PDF (via a migradoc table, then rendered to the PDF at the end) which will flatten the image or something similar? Or, I am using Illustrator to convert from .eps to .pdf - is there a setting in there i need to change to get this image to work? I have fiddled about with the export settings in Illustrator a bit, but with no success...
I can save the problematic image as a .jpg and add it fine, but obviously because its not a vector, the quality is much poorer when zoomed etc. so i would definately prefer to avoid this solution.
I have tried to attach a .zip file containing the three pdf's 1 which is the main pdf, and two which are the images being added to the main pdf, but i cant seem to upload them individually (get invalid image error) and when i zip them, it says the file is too big (its 2.6mb and says its limited to 256kb)
I can provide these files via a public FTP link if required.
Thanks,
Mike
|